.STL File / 3D model: BOX WITH SLIDING TOP

A customizable box with a sliding top with a little grab.

In the event you make, I had adore to see your prints of this one!

V2 contains optional dividers are included by now. Examine the customizer to add more (or less) dividers.

The stl will produce a box that carries 4 pills that are oblong. Strike the customizer to adjust the measurements.

Directions

Customize!

Print!

Clean up!

  • That is a tiny slit on the bottom of the lid that must be cleaned up to make sliding the lid open a bit more easy.
  • It might be advisable to sand the lid edges only a bit in the event the fit is overly close.

Use!

  • A little bit of toilet tissue or folded paper towel in the base of the carton helps keep the pills from turning to dust and rattling around.

Be aware of the overhang angle on the lid. The .scad file will output the angle in OpenSCAD. An angle < 45 is probably a good idea.

21464 Views 5139 Downloads

Tags


Related designs

ldr