Upgrade 17th of August 2015
Now even smaller (filename Watchstand_H5.STL, orange in pictures), and also you may pick which method to route the cable. I 've a 38mm-variation in the works but before posting it, I desire to examine it. The 38mm will follow the attraction, therefore it is going to work, but it may slide off, which might prevent it from charging. Remain tuned.
Suggestions for printing: Large flat bottom down, use support, possibly a raft (I utilize a raft, works excellent). I also turn it so that the "seam" (where each layer starts/stops) is along the rear for tasteful reasons. :) See picture for more rapid explanation.
Inspired by the new "Nightstand-style" in watchOS 2, hereis a flat nightstand-charging-stand... I use some blue tack on the underside to stop it from slipping around when I attempt to shut up the alarm in the morning. The file is somewhat distinct from the pictures, but not in a leading manner that is practical. Like all my creations, it may be a bit tight, so some sanding may be desired. Additionally, support is required by this one. Love.
200 micron, 2 casings, with support on a Rep2. Possibly a raft.