.STL File / 3D model: APPLE WATCH CHARGING STAND WITH BASE FOR IPHONE

Inspired by the mentioned models, I thought it'd be wonderful to put my phone below the watch at night while charging.

Gives the construction a solid stand and a surface for the iPhone.
IPhone 6Plus Models also needs to match below.
(Tried it with a case I found here: http://www.thingiverse.com/thing:471548)

The 5S and all preceding ones should fit even better.

Hope you enjoy it :-)

EDIT: Gave first layers one 'mm' more so the border is stronger
-> choose yourself, that is 1mm more infill

Please discuss your makes. Would like to known if you are delighted with it.

Instructions

The "plus one mm"-Version will probably increase your Watch-Stand a bit.
You may need to clean this part slightly more.

Works fine though (check my make)
You cannot tell that the stand is raised, the socket fits so tight that it will not lean either.

The "plus one mm"-Model was added for Printers using 0.3 or 04 layers.
I'm printing z-0.1millimeter thickness so the first gives me 7 Layers at the front before separating to the steep planes; enough to become solid.

Also:
If you're printing with infill touching ground, there is not any reason (besides the optical ones) to eliminate it. It just didn't feel right to provide a strong Model ;--RRB-

I'm open for suggestions.

If you like it, "like it", if not:
Comment and I'll attempt to improve

9899 Views 2652 Downloads

Related designs

ldr