.STL File / 3D model: APPLE WATCH AND IPHONE CHARGING STATION

I enjoyed the original model a lot, but didn't need the phone supported solely on the lightening cable, so I extended supports at the back in order for it to rest against. It is calibrated for an iPhone 5 + case. (it extends roughly 5/16 of an inch behind the connector. (the part that plugs into the telephone, not the plug body)

Also notice that the plug is not sitting down as far as it could. (since the phone has a situation) Thank you hot glue.

Finally, I needed to widen the station a bit to get the cable in with a screw driver and some sandpaper. (this may be b/c of the non apple cable I used)

Instructions

Makerbot moderate print (.2 mm) with 10% infill. Raft and support (needed for the watch charger stage).

11296 Views 2422 Downloads

Related designs

ldr