>>> THIS ISN'T DEVISED BY ME. THIS IS DEVISED BY MARK MANGER. I STRONGLY URGE TO GO TO GROPENER WEBSITE: "https://www.gropener.com/". THERE YOU CAN PURCHASE THE FIRST BOTTLE OPENER MADE IN ALUMINUM. <<<
>>> GrOpener is the development of Mark Manger, an Employed Artist from Denver, Colorado. Inspired by screw openers Mark struck in Africa in the 1990 & the stick?s, the same leverage principle is used by the GrOpener, but in a form that enables a bottle to be opened via the action of catching it. <<<
Job video in Finnish (UPGRADE: ENGLISH SUBTITLES AVAILABLE) (v.3.1): WITH SUPPORT STUFF (there's a small overhang!)
My first 3D creation
Versio 4 (updated 23.6.14):
Now there's 4 different versions:
- Edition one: Fundamental OHBO
- Edition two: OHBO with magnet.
- Edition three: OHBO with a coin.
- Version four: OHBO with magnet as well as a coin.
BTW: Other side (tail) of OHBO is supposed to opening cans! (You are able to stick it below the clip)
Magnets from dx.com (here is a link: http://www.dx.com/p/10050078w-round-ndfeb-magnets-silver-50-pcs-239991)
Coin is a fundamental 1cent euro coin.
If printing a Version 2,3 or 4.! additionally, you will need some super glue
All versions analyzed and are scaled. I would suggest to print with 100% infill (layer height 0.2mm). My prints are PLA plastic but I believe ABS is better because it's more powerful and tougher! I am hoping you to make one! I like to see how is your own bottle opener like!