.STL File / 3D model: OPENR/C 1:10 FORMULA 1 CAR BY DANIELNOREE 🚂

Please respect the permit under which this project is published. Thank you!

This is the OpenR/C Formula 1 car. It´s the third generation OpenR/C car and this time around focus is on ease! You can print everything in PLA! Of course you can print it in any material you like but this is the job for you!

A note on the servo saver. It´s designed to be used with PLA, the upper and lower BOM applies force similar to a spring at a servo saver. Of course the pressure is based upon the type of material used, infill etc.. Fine tuning can be done adding washer under or over the servo saver.

The "Main Turning Vane´s" needs to have it´s lower part trimmed using a "exacto knife". Then slide it in the chassie plate and push it on the "Lid" and it should snap into position-

Additional:

Front Spoiler.stl

Front.stl

Rear Rim.stl

Rear Wing.stl

Servo Saver Lower.stl

Things to buy:

Ok you need some filament which you´ll get out of your filament supplier.

You need M3 nuts and screws that you may get at your local hardware store. For what to expect, check the BOM list.

Some bearings are required aswell, check the BOM list or purchase a kit from FastEddyBearings.com:http://www.fasteddybearings.com/openrc-f1-sealed-bearing-kit/

Last but not least you need electronics and here´s what i got, all from HobbyKing:

ESC and motor combo:http://www.hobbyking.com/hobbyking/store/__65982__TrackStar_ROAR_approved_1_10th_Stock_Class_Brushless_ESC_and_Motor_Combo_21_5T_.html

Battery:http://hobbyking.com/hobbyking/store/__23134__Turnigy_nano_tech_Shorty_4200mah_2S2P_65_130C_Hardcase_Lipo_Pack_ROAR_APPROVED_.html

Micro Servos not good, please let me know when you have a revommendation. http://www.hobbyking.com/hobbyking/store/__7472__Turnigy_8482_TGY_1800A_Servo_1_5kg_0_10sec_8g.html

Transmitter and Receiver (I use something else but this is a "cheap" option):http://hobbyking.com/hobbyking/store/__83360__HobbyKing_174_8482_HK_GT2B_3CH_2_4GHz_Transmitter_and_Receiver_w_Rechargable_Li_ion_Battery.html

If you're new to this hobby you´ll require a LiPo charger to the battery. Request from the Google + Community for recommendations:https://plus.google.com/u/0/communities/112745535856143176146

Rain tires designed by Thomas Palm are available here:http://www.thingiverse.com/thing:999257

Low profile rims & tires designed by Thomas Palm are available here:http://www.thingiverse.com/thing:1103751


Related designs

ldr