.STL File / 3D model: COMPACT HEADPHONES HOLDER

This is a headphone holder that is compact.

After several failed attempts at holders, I made a one that works great.

Instructions

  1. Skeinforge
  2. Printing
  3. Use!

NOTE: If there are ANY spots lacking loops (perimeter only), then you need to slice it with a higher density profile.

Utilization
  1. Insert headphones into holes vertically and turn flat to lock them in place.
  2. Cross the ends and wrap around the device (self explanatory).
  3. When done wrapping, take the plug and then stick it into the little hole, then push into the thin part. Assuming you used Widen, it'll snap quite nicely.

Related designs

ldr